PREPARATION
Before assembling your Folding Creeper, make sure all parts are present. If any part is missing or damaged, do not
attempt to assemble or use the product. Contact JEGS customer service for replacement parts.
Package Contents:
(1) Head Frame Section (1) Middle Frame Section (1) Rear Frame Section (4) Hex Bolts
(8) Washers (4) Hex Nuts (6) Casters (4) Caster Fasteners
ASSEMBLY INSTRUCTIONS
(1) Place Creeper Sections face down, arranged as shown in Fig. 2 (note Middle Section orientation).
(2) Connect Creeper Sections using Hex Bolts, Washers and Nuts. Use two M8 x 60 bolts to connect Head Frame
to Middle Frame. Use two M8 x 55 bolts to connect Middle Frame to Rear Frame. Tighten Nuts firmly, but not
enough to bind Creeper adjustment.
(3) Insert Lock Pin into hole in frame side. Check for proper operation.
(4) Using the included open-end wrench, attach two Casters to the threaded holes in the Head Frame section. Use
a 5mm hex key to fasten the remaining four Casters to the Creeper Frame. Insert the threaded Fasteners from
the top and the Casters from the bottom, and then tighten with hex key.
OPERATING INSTRUCTIONS
(1) Unlock the spring loaded Lock Pin by pulling out until disengaged, at the same time rotate the Head Frame and
Middle Frame upward and back towards the Rear Frame section until the Lock Pin can engage the Creeper
Seat Locking Sleeve (Fig. 4). Ensure Lock Pin is fully engaged.
(2) Flip Head Frame forward until horizontal.
(3) Unlock the spring loaded Lock Pin by pulling out until disengaged, then reverse steps 1, 2 to convert Creeper
Seat into Creeper.
MAINTENANCE
Wipe clean as needed. Use mild upholstery cleaner (not caustic) to clean seat as needed.
CAUTION:
Do not lubricate casters
1-800-345-4545 jegs.com
Figure 2 - Creeper Frame
assembly
Figure 3 - Attaching Creeper Casters
Figure 4 - Adjusting Creeper to seat
configuration
Figure 5 - Adjusting Seat to Creeper
configuration
