3
USER MANUAL
JEFJKGAR03
3 TONNE TROLLEY JACK
www.jeffersontools.com
1. Safety
IMPORTANT: READ ALL INSTRUCTIONS BEFORE USE
Regularly inspect and lubricate the jack to ensure it is in good
working order and condition.
DO NOT
use the jack if damaged
or a fault is suspected - check Section 6 Troubleshooting. If
necessary, immediately repair or replace damaged parts.
• Use recommended parts only, the use of unauthorised parts
may be dangerous and will invalidate your warranty.
• Ensure the work area is clean, tidy and free from unrelated
materials and has adequate lighting.
• Use jack on level and solid ground, preferably concrete.
Avoid tarmacadam since jack may sink in.
• Park the vehicle and apply hand brake (if automatic, place in
“Park” mode). Switch off the engine and place chocks under
the wheels.
• Ensure a minimum distance of 0.5m between vehicle and
static objects such as doors, walls, etc. to allow for tilting
during jacking.
• Ensure all persons are out of the vehicle before jacking.
DO NOT
enter vehicle whilst it is supported on the jack or
axle stands.
• Check vehicle weight and recommended lifting points by
referring to the vehicle owner’s manual. Ensure the lifting
point is not corroded.
• Check lifting point is centred and stable on jack saddle (off
centre loads can slip). Position jack so as to avoid operating
it from under vehicle.
• Keep hands etc. clear of moving parts during raising and
lowering of the vehicle.
DANGER!
Roadside wheel changing is hazardous. Be extra
vigilant, you may not be able to avoid jacking on tarmacadam.
Get everyone out of vehicle.
NEVER
go under vehicle. Traffic
may cause vehicle to rock. Use hazard warning lights. If in
doubt call professional help.
• When changing a wheel, slightly loosen wheel nuts/bolts
prior to jacking vehicle. Screw wheel nuts/bolts back before
lowering vehicle. Finally tighten when vehicle is fully lowered.
• Use a qualified person to lubricate and maintain the jack.
Confirm that only recommended hydraulic jack oil is used
during maintenance.
•
DO NOT
exceed the rated capacity of the jack and
DO NOT
operate the jack beyond its maximum pump stroke.
WARNING!
DO NOT
allow the vehicle to move, or try to start
the engine, when the vehicle is jacked up.
• Ensure there are no persons or obstructions beneath the
vehicle before lowering.
• Clean and securely stow the jack with the ram in the down
position.
DO NOT
leave the ram extended. Ensure stowage
area is dry.
WARNING!
Remember, it is very dangerous to go under a
vehicle supported by a jack even if additional supports are used.
DANGER! USE THE JACK FOR LIFTING ONLY, NOT
FOR SUPPORTING THE LIFTED LOAD. ALWAYS USE
ADEQUATELY RATED AXLE STANDS.
•
DO NOT
jack a vehicle if it may result in the spillage of fuel,
battery acid, or other dangerous substances.
•
DO NOT
place any part of your body under vehicle whilst
it is supported by the jack. Wait until adequately rated axle
stands have been correctly positioned.
•
DO NOT
use jack to support extensions or cradles.
DO NOT
modify jack in any way.
DO NOT
use the jack
for any other purpose.
•
DO NOT
top up jack with brake fluid. Use hydraulic oil only.
DO NOT
adjust the safety overload valve.
•
DO NOT
go under a vehicle unless it is supported by
adequately rated axle stands.
NOTE:
Seek advice before
jacking caravans or trailers.
