Jefferson Professional Tools & Equipment JEFWASPET075HP, Руководство пользователя

Страница: 9 / 32

JEFWASPET075HP
7.5HP Petrol Pressure Washer
9
www.jeffersontools.com
Starting the Washer
7.
1. Ensure that the equipment is operating in a well ventilated outdoor area. Check fuel level and top-up if
necessary.
2. Check the engine oil level. On first use there will be a small amount of oil left from factory testing but this
will always require topping up.
This equipment is shipped with a low-oil sensor that will prevent startup if insufficient oil is
available for operation. The low oil sensor will also shut down the engine when level is too low to protect the
engine.
3. Check that the filter is clean and in place at the water inlet (cone side facing out).
4. Connect the water supply to the pump inlet. (Note: the water source must provide a minimum of 19L / Min
at 20PSI for this equipment to operate.
5. Connect the high pressure water hose to the pump outlet. Turn on the water supply.
6. Make sure that the Throttle lever is set to the "Fast" position. Slide the fuel lever to the "On" position and
allow the fuel to flow to the engine. Slide the choke lever to the "Start" position. Turn the Engine ON/OFF
switch to the ON position. Pull the starter cord to start the engine. Slide the choke lever to RUN position.
7. Stand on a stable surface, gripping the gun with both hands, and press the trigger to begin spraying -
expect the gun to kickback when triggered. Adjust the spray nozzle as required for the task.
8. Release the trigger to stop water flow and enter bypass mode pior to spraying.