Jeep Patriot, Руководство пользователя, Страница: 142 / 425

Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink
t
button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink
t
has successfully accepted the frequency signal. The
indicator light will flash slowly and then rapidly when
fully trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink.” earlier in this section.
Using HomeLink
T
To operate, simply press and release the programmed
HomeLink
t
button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.
Reprogramming a Single HomeLink
T
Button
To re-program a channel that has been previously
trained, follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink
t
button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
142 UNDERSTANDING THE FEATURES OF YOUR VEHICLE