Jeep Patriot, Руководство пользователя, Страница: 139 / 425

WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.
Programming HomeLink
T
Before You Begin
If you have not trained any of the HomeLink
t
buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
t
for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLink
t
button you wish to program.
Place the hand-held transmitter 1–3 inches (3–8 cm) away
from the HomeLink
t
button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink
t
button and the hand-held transmitter button
until the HomeLink
t
indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
t
and hand-held transmitter buttons.
Watch for the HomeLink
t
indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open & close while you train.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
3