JOBNAME: CHRY OM INTL (Conten PAGE: 210 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 39B59272
/chry_pdm/chrysler/owners/grc/og
gears for 5.7L engine). The transmission will
automatically shift to Overdrive, if the following
conditions are present:
•
the shift lever is in DRIVE;
•
the engine coolant has reached normal op-
erating temperature;
•
vehicle
speed
is
above
approximately
30 mph (48 km/h);
•
the TOW/HAUL switch has not been acti-
vated;
•
transmission has reached normal operating
temperature.
NOTE:
If the vehicle is started in extremely cold
temperatures, the transmission may not
shift into Overdrive and will automatically
select the most desirable gear for operation
at this temperature. Normal operation will
resume when the transmission fluid tem-
perature has risen to a suitable level. Refer
to the “Note” under “Torque Converter
Clutch” in this section.
During cold temperature operation you may
notice delayed upshifts, depending on en-
gine and transmission temperature. This
feature improves the warm-up time of the
engine and transmission.
If the transmission temperature gets ex-
tremely hot, the transmission will automati-
cally select the most desirable gear for op-
eration
at
this
temperature.
If
the
transmission
temperature
becomes
hot
enough, the “TRANSMISSION OVER TEMP”
message may display, and the transmission
may downshift out of Overdrive until the
transmission cools down. After cool down,
the transmission will resume normal opera-
tion.
The transmission will downshift from Overdrive,
to the most desirable gear, if the accelerator
pedal is fully pressed at vehicle speeds above
approximately 35 mph (56 km/h).
When to Use TOW/HAUL Mode – If
Equipped
When driving in hilly areas, towing a trailer,
carrying a heavy load, etc., and frequent trans-
mission shifting occurs, press the TOW/HAUL
switch. This will improve performance and re-
duce the potential for transmission overheating
or failure due to excessive shifting. When oper-
ating in TOW/HAUL mode, the transmission will
shift into direct gear and Overdrive will be
enabled under steady cruise conditions.
The “TOW/HAUL Indicator Light” will illuminate
in the instrument cluster to indicate when the
switch has been activated. Pressing the switch
a second time restores normal operation. If the
TOW/HAUL mode is desired, the switch must
be pressed each time the engine is started.
TOW/HAUL Switch
208
art=051210681.tif
NO TRANS
Содержание Grand Cherokee WK2
Страница 154: ...JOBNAME CHRY OM INTL Conten PAGE 154 SESS 2 OUTPUT Fri Jun 4 10 52 37 2010 SUM 000FE011 chry_pdm chrysler owners grc og ...
Страница 196: ...JOBNAME CHRY OM INTL Conten PAGE 196 SESS 2 OUTPUT Fri Jun 4 10 52 37 2010 SUM 000FE011 chry_pdm chrysler owners grc og ...
Страница 302: ...JOBNAME CHRY OM INTL Conten PAGE 302 SESS 2 OUTPUT Fri Jun 4 10 52 37 2010 SUM 000FE011 chry_pdm chrysler owners grc og ...