Jeep 2013 Grand Cherokee, Руководство пользователя

Страница: 16 / 148

• If “Unlock All Doors 1st Press” is programmed all doors and liftgate will unlock
when you press the liftgate button. If “Unlock Driver Door 1st Press” is pro-
grammed only the liftgate will unlock when you press the liftgate button. To select
between “Unlock Driver Door 1st Press” and “Unlock All Doors 1st Press”, refer to
the Electronic Vehicle Information Center (EVIC) in your vehicle's Owner's Manual
on the DVD or Programmable Features in this guide for further information.
• If a Key Fob is detected in the vehicle when locking the vehicle using the power
door lock switch, the doors and liftgate will unlock and the horn will chirp three
times. On the third attempt, your Key Fob can be locked inside the vehicle.
• After pressing the Keyless Enter-N-Go™ LOCK button, you must wait 2 seconds
before you can lock or unlock the vehicle using the door handle. This is done to
allow you to check if the vehicle is locked by pulling on the door handle without the
vehicle reacting and unlocking.
• If a Keyless Enter-N-Go™ door handle has not been used for 72 hours, the Keyless
Enter-N-Go™ feature for that handle may time out. Pulling the deactivated front
door handle will reactivate the door handle's Keyless Enter-N-Go™ feature.
Lock Or Unlock The Liftgate:
• With a valid Keyless Enter-N-Go™ Key
Fob within 3 ft (1.0 m) of the liftgate,
press the button located to the right of
the liftgate handle to unlock the lift-
gate. Press the button a second time to
lock the liftgate.
NOTE:
Refer to your Owner's Manual on the DVD
for further information.
Installing And Removing The ENGINE START/STOP Button
Installing The Button
• Remove the Key Fob from the ignition switch.
• Insert the ENGINE START/STOP button into the ignition switch with the lettering
facing up and readable.
• Press firmly on the center of the button to secure it into position.
GETTING STARTED
14