Jeanneau Sun Odyssey 40, Руководство пользователя

Страница: 47 / 115

24
58
5
index 1
Proceed as follows to install or remove the mast on your own:
BEFORE MAST INSTALLATION:
- Protect the mast from chafing with the hook and hoist cable,
- Secure the shrouds and ropes to the mast base with a hitch of sufficient length to
guide the mast foot during handling,
- Protect the spreaders end pieces,
- Install a 1.50 m rope around the mast with a thimble on each and wrapped with
rags. Install the rope below the second tier of spreaders. Connect both thimbles
by means of a sufficiently strong shackle to receive the crane hook, ahead of the
mast. Raise the assembly until it is taut under the spreaders basis.
DURING MAST INSTALLATION:
- Take all steps necessary to avoid damaging the equipment on mast head,
- Control the handling by means of the backstay and mast base hitch,
- Ensure that the mast base rests fully on its support plate.
AFTER MAST INSTALLATION:
- Check the spreaders for security and position: they must always be above the
horizontal,
- Lubricate all bottlescrews (refer to “Hints”, chapter 5),
- Make the shrouds fast (refer to chapter 5 for “Settings”),
- Insert the wires in the cable glands, re-feed the cable glands and connect up the
electrical cables (refer to chapter 8 “Electricity”),
- Carefully check that the bottlescrews securing pins are locked and protected by
adhesive tape.
- Re-install the boom and refit all ropes,
Adjust the mast again after a few trips out to sea.
MAST DISMANTLING:
Proceed in reverse order taking care to mark the rope locations with stickers.
D
D
A N G E R
A N G E R
Before mast installation, be sure to have enough room to move.
Contact or closeness of electric wires may incur electrocution.
STANDING RIGGING
rig and sails