Setting a secondary anchor:
•
Your secondary anchor is a quick set type of anchor and is usually stored in the cockpit
locker. It has 30 feet of chain and about 170 feet of line. For this reason, we have always
found it easiest to put this chain in the dinghy with two people and deploy it from there. Take
note where your primary is and drive away from the yacht at a 45-degree angle of the
primary. Drop the anchor with the shank pointed at the yacht and deploy the rode as you
drive back to the bow of the yacht. Tie off at the bow. Once back on the yacht and dinghy
secured, manually take the slack out of the 2
nd
rode and tie off. Now engage reverse to 1500
RPMs as before.
Manual operation of the windlass
If you lose power to your windlass, start the engine and rev to 1500 rpms to make sure you
have not got low battery voltage
. Check that the breaker shown below has not tripped behind
the panel at the nav desk.
If you still have no power, you can operate the windlass manually.
To drop the anchor, insert the windlass handle into the central hole on the top of the windlass.
Turn the handle anti-clockwise so that the gypsy loosens its grip on the chain. Your anchor is
now ready to drop.
Содержание 54 2017
