JDS Uniphase TestifierPRO, Руководство пользователя

Страница: 11 / 40

7
in that position and a message of
“High-R Fault” displayed on the third
line�
• If a split pair is detected,
corresponding pin positions on the
second line will display flashing pin
numbers detected from the remote�
The specific split conditions are
displayed on the third line�
• If there are multiple errors to display
on the third line, messages for the
highest severity errors are displayed
in sequence until all are displayed�
So if there are both shorts and
high-R Faults, only messages for
the shorts are cycled through� The
ID icon will have a number directly
below it indicating the remote ID
number�
If there is no remote, the TestifierPRO
f
uses the length and cable test capability
to attempt to measure a cable for shorts,
opens and split pairs (Pretest�) While
the test is in progress the test icon and
the wire numbers for the pair being test
are displayed. The final test results are
displayed as messages on the LCD�
Because a test can take up to about 5
seconds to complete, the SEL button,
which immediately starts a new test,
should be pressed whenever a new