Page 2
ONT-601 MTM will either look for a DHCP assigned address, or default to its fixed address
(see next chapters).
4. On your PC, configure the following network settings:
• IP Address: 192.168.0.100
• Subnet mask: 255.255.255.0
• Default gateway: 192.168.0.1
Existing LAN Infrastructure - DHCP assigned addressing
Use this method to assign the MTM IP address using a DHCP server. The MTM is shipped
from the factory for this type of connection.
1. Connect an RJ-45 cable from the MTM faceplate Ethernet port to your network hub or
remote jack.
2. Power on the MTM, and a DHCP request is issued on boot-up.
If the MTM has already been powered on, you may depress the recessed black IP reset but-
ton (highlighted within the white box below) with a paper clip, ball point pen, or similar
instrument until the red LED illuminates and hold for a minimum of 2 seconds. Ensure to
only depress the button until it reaches the end of its travel to avoid damage to the switch.
3. Verify the IP address and netmask have been correctly assigned by checking the LCD
display on the front panel.
Note: If the default IP address 192.168.0.101 is shown on the LCD display, then the DHCP
server is not available or there was a LAN issue that prevented the MTM from
acquiring a DHCP address from the server. If this happens, try rebooting the MTM,
try using the Static IP procedure instead, or consult with your network administra-
tor.
Existing LAN Infrastructure - Static IP
Use this method when a static IP address will be assigned to MTM. Note that the IP address
must be unique for your network (i.e. not in use by another device) to avoid any conflict.
Please consult your network administrator if necessary.
1. Go through all of the steps described in “Direct to PC Connection” or “Existing LAN
infrastructure - DHCP assigned addressing”, depending on which of the two apply to your
setup.
2. Go through the steps described in “Connecting and using the GUI system” on page 3 until
you see the “Welcome to ONT-601 MTM 4s4x” page.
3. Now select Launch ONT Scout link in order to get access to the IP setup function.
