Chapter 3 Ethernet Testing
OAM service and link layer testing
HST-3000 Ethernet Testing User’s Guide
99
5 Use the right arrow key to go to the S-OAM LBM/LBR
configuration menu, and then specifying the following:
MD Level
Specify the level for the
Maintenance Domain
(MD).
The instrument will indi-
cate whether AIS for the
specified level are
detected in the traffic
stream.
AIS Rate
Specify the rate at which
the instrument will trans-
mit AIS.
NOTE: 3.33ms and 10ms
rates are not supported
AIS Type
(non MAC-in-MAC applica-
tions only)
Select one of the follow-
ing:
–
Unicast. Select Uni-
cast to send AIS to its
destination address.
–
Multicast. Select Mul-
ticast to send AIS to a
reserved multicast
MAC address.
This setting does not
appear when running
Mac-in-Mac applications.
Setting
Parameters
LBM/LBR (ping)
If you want to test LBM or
LBR, select Enable; oth-
erwise, select Disable,
and proceed to
NOTE: When you enable
this setting, a Send LBR
action is available.
Setting
Parameters
Содержание IP Video Test Option HST-3000
