Page 9 of 14
2.5 Outbound Call Testing
Step
Action
Details
1.
Dial
Press 1 to Enter Destination Alias. Using the HST-3000 keypad or USB
keypad, enter the Destination Alias for your cell phone and press
OK
.
For Registering trunks, enter the phone number. For non-registering
trunks, enter a URI as follows: Phone Number@SBC LAN IP Address.
i.e. “[email protected]”.
Notes:
•
Use third softkey to toggle between “Keypad:123” for numerical entry
(including “.”)
and “Keypad:abc” for text entry (including “@”).
•
Press “1” seven times to enter “@”
•
Press “*” once to enter “.”
2.
OK
Press
OK
again to go off hook and place the call. The HST-3000 will
send an INVITE message to set up the call. Call status is displayed in
the VoIP Phone results screen.
3.
Answer
Answer the incoming call on your cell phone. “CONNECTED”
indicates that the call setup was successful.
4.
Converse
Confirm that Voice is heard and Voice Quality is good on the HST-3000
and on the Cell Phone.
5.
Troubleshoot
If “
CONNECTED”
is not displayed in step 3 or voice is not heard in
step 4, verify that the HST-3000 setup is correct and that your cell phone
is working properly and repeat step 1. If “
CONNECTED”
is still not
displayed, the test has failed. Contact VoIP Technical Support.
Technical Support
1 866 228-3762
