Chapter 2
Auxiliary and Common Commands
Auxiliary commands
CT-650 Command-Line Reference Guide
Release 9.4
29
Line_Coding
Sets the line coding of the transmitted signal.
Syntax
Line_Coding {AMI | B8ZS}
Remarks
– Use this command to override the default line coding for an indi-
vidual test.
– Use the
Information Configure Default
command to view
the default line coding.
Logout
Logs off the system and returns the system prompt.
Syntax
Logout
Remark
Before logging out, be sure to terminate any existing tests using the
Disconnect
command (
).
Loopback
Transmits latching loop-up and loop-down codes.
Syntax
Loopback <
> Up|Down <
num_repeaters <
Loopback <
> DS1 {Up Down} <
<
Sends the DS1 loop-up or loop-down codes (in-band or FEAC) for the
desired
ds1_device
and
channel
on the chosen digroup side.
Loopback <
> DS3 {Up Down} <
Sends the DS3 FEAC loop-up or loop-down codes on the chosen
digroup side.
Remark
– This command is available only after executing a
Measure
command.
Содержание CT-650
