Figure 1
Figure 2
WARNING:
Figure 3
Figure 4
Figure 5
Figure 5a
Failure to properly engage the spring loaded buttons may cause
the handlebars to dislodge while riding and may cause you to lose
control and fall. When correctly engaged the handlebars will not
rotate nor will they move sideways. Note that when properly
engaged, the spring loaded buttons are clearly visible in the holes
in the T-tube (Figure 2)
B.
To release the folding mechanism, grasp the T-tube with one hand between
the collar clamp and the quick release clamp and with the other hand press
down the folding release mechanism (Figure 3) to release the steering
column from the locked position and allow you to pivot it to the upright
position. The folding release is spring loaded and will automatically lock in
the upright position when fully upright (Figure 4).
Keep your fingers clear of the pivoting mechanism when folding
or unfolding the scooter. Make sure others are standing clear.
A.
Insert and secure the left and right handlebars by pressing the spring
loaded buttons and inserting them into the T-tube (Figure 1). Make certain the
spring loaded button engages the hole in the T-bar for each handlebar (Figure 2).
JD BUG SCOOTER ASSEMBLY
C.
To extend the handlebars, unlock the steering tube by pulling outward on
the quick release lever. Pull the T-tube to the position where the spring loaded
button inserts into the tube and secure by pushing inward on the quick release
clamp (Figure 5 and 5a). The tension of the quick release clamping mechanism
can be adjusted by tightening or loosening the Allen bolt. Be careful not to over
tighten.
You should always be able to open and close the quick release lever by hand and
the T-tube should telescope freely with the quick release open.
Failure to properly engage the quick release clamp may cause the
T-tube to telescope up or down while riding which may cause you
to lose control and fall. With the quick release properly adjusted
and engaged, make sure the spring loaded button inserts into the
tube and will not move up or down.
WARNING:
WARNING:
CHECK BEFORE RIDING
A.
Using the correct size Allen key, check that the collar clamp bolt (Figure 6)
is tightened securely (30-60 inch pounds torque). This item is tightened and
quality inspected at the factory, but there is a slight chance that the effects of
shipping or handling may have caused this bolt to loosen.
Figure 6
Содержание MS-305
Страница 1: ......
