JCM RS3 TGL868NF, Руководство пользователя

Страница: 7 / 16

RS3 SYSTEM
jcm technologies
7
2. Installation
2.1 Mechanical installation
Install the transmitter following the steps and recommendations below. Pass the cables through the holes
indicated (only if you use the lock connection).
Install the transmitter in a horizontal position, at the middle of the last slat (it must have a tolerance of minimum
2mm of movement). Avoid placing metallic surfaces between the receiver and the transmitter.
It is recommended to use limit switches in the installation and to have them properly connected, or to assure
that the door will stop always at the same point. The speed of the door must be uniform.
Options and sensibility selectors must be set before programming. Any later change will have no effect.
SWIPE TO OPEN COVER REMOVE PLASTIC DRILL DOOR
Maximum width of the
door: 4 m
Recommended
door
speed: 0.1m/s or higher
(and 17 rpm motors).
<10m