JCM ivizion ld, Эксплуатация и обслуживание

Страница: 61 / 158

P/N 960-100929R_Rev. 7 {EDP #148849} © 2017, JAPAN CASH MACHINE CO., LTD.
4 - 5
Disassembly/Reassembly iVIZION® Series Next-Generation Banknote Acceptor Unit Section 4
.
14. Remove the Outer Guide L (Figure 4-17 a ) from
the Pusher Assembly (Figure 4-17 b ).
15. Remove the two (2) Timing Belts (Figure 4-18 a
1
& a
2
) from the Pusher Assembly.
Home Position Sensor Board/
Home Position Sensor, FFC &
Interface Connector Board
Removals
To remove the Home Position Sensor Board, the
Home Position Sensor FFC and the Interface
Connector Board proceed as follows:
1. Remove the Transport Unit from the
iVIZION
Unit.
2. Remove the Validation Section from the Trans-
port Unit.
3. Remove the two (2) TR Cover mounting Screws
(Figure 4-19 a
1
& a
2
) from the bottom of the
Transport Unit, and remove the Transport (TR)
Bottom Cover (Figure 4-19 b ) off the Transport
Unit.
4. Use a small Screwdriver to release the five (5)
Click-tab Stops of TR Side Cover “A” (Figure 4-
20
a
1
to a
5
), and remove TR Side Cover “A” (Fig-
ure 4-20 b ) from the Transport Assembly.
Figure 4-16 Outer Guide L Removal 1
Figure 4-16 Outer Guide L Removal 1
c
b
a
1
a
2
d
NOTE: Be careful that the two (2)
Bushings (Figure 4-17 c
1
& c
2
) and
the Plate Nut (Figure 4-17 d ) are not
lost when removing them.
Figure 4-17 Outer Guide L Removal 2
Figure 4-17 Outer Guide L Removal 2
a
b
d
c
1,
c
2
NOTE: When replacing the Outer
Guide L, ensure that the Plate Nut is
correctly repositioned (Figure 4-17 d ).
Figure 4-18 Timing Belt Removal
Figure 4-18 Timing Belt Removal
a
1
a
2
b
NOTE: The Timing Belts should be
replaced as illustrated in Figure 4-
18 b when reassembling the Unit. Be
careful that the Pulleys and/or
Rollers do not fall off during
reassembly.
Figure 4-19 TR Bottom Cover Removal
Figure 4-19 TR Bottom Cover Removal
a
1
a
2
b
Figure 4-20 TR Side Cover “A” Removal
Figure 4-20 TR Side Cover “A” Removal
a
1
a
2
a
4
a
5
a
3
b
NOTE: When the three (3) lower
Click-tab stops are difficult to
remove from the top, release them
from bottom-side instead.