JCM ivizion ld, Эксплуатация и обслуживание

Страница: 58 / 158

P/N 960-100929R_Rev. 7 {EDP #148849} © 2017, JAPAN CASH MACHINE CO., LTD.
4 - 2
Section 4 iVIZION® Series Next-Generation Banknote Acceptor Unit Disassembly/Reassembly
6. Remove the two (2) Flat Springs, the single (1)
Stacker Guide (Figure 4-4 a ), the single (1) Pin
0360 (Figure 4-4 b ), the two (2) Rollers (Figure 4-
4 c
1
& c
2
) and the single (1) related pressure Coil
Spring (Figure 4-4 d ) from the Pusher Mechanism
Assembly.
7. Remove the single (1) E-ring (Figure 4-6 a ) and
the single (1) Gear (Figure 4-6 b ) located on the
right side of the Transport Unit.
8. Remove the three (3) Assembly Mounting Screws
(Figure 4-6 e
1
, e
2
& e
3
) located on the right side
of the Transport Unit, and remove the Right
Frame Outer “R” Assembly (Figure 4-6 f ) from
the Transport Unit.
9. Remove the single (1) E-ring (Figure 4-7 a ) and
the two (2) Gears (Figure 4-7 b
1
& b
2
) located on
the left side of the Transport Unit.
10. Remove the three (3) Assembly Mounting Screws
(Figure 4-7 e
1
, e
2
& e
3
) and remove the Left
Frame Outer “L” Assembly (Figure 4-7 f ) from
the Transport Unit.
Figure 4-3 Pusher Mechanism Cover Removal
Figure 4-3 Pusher Mechanism Cover Removal
a
2
a
1
a
4
a
3
b
Figure 4-4 Stacker Guide Removal
Figure 4-4 Stacker Guide Removal
b
d
a
c
1
c
2
NOTE: When reassembling the
Stacker Guide (Figure 4-5 a ),
ensure that the Coil Spring (Figure
4-5 b ) is replaced in the correct
direction. When reinserting the Pin
0360, put it in place while lifting the
Flat Leaf Springs upward; then
install the screws securing each Flat
Leaf Spring in place. Apply Screw
Lock Compound to the head of each
screw to secure.
Figure 4-5 Stacker Guide Reassembly
Figure 4-5 Stacker Guide Reassembly
a
b
NOTE: Be careful that the parallel Pin
(Figure 4-6 c ) and the related
Bushings (Figure 4-6 d
1
& d
2
) are not
lost when removed.
Figure 4-6 Right Frame Outer “R” Removal
Figure 4-6 Right Frame Outer “R” Removal
a
b
c
d
1
e
1
e
2
e
3
g
d
2
f
NOTE: When replacing the Frame
Outer “R” Assembly, ensure that the
Plate Nut is correctly re-positioned
(Figure 4-6 g ).
NOTE: Be careful that the parallel
Pin (Figure 4-7 c ) and their related
Bushings (Figure 4-7 d
1
, d
2
& d
3
) are
not lost when removed.