P/N 960-100929R_Rev. 7 {EDP #148849}
© 2017, JAPAN CASH MACHINE CO., LTD.
4 - 1
Next-Generation Banknote Acceptor Unit
S e c t i o n 4
This section provides disassembly and reassembly
instructions for the iVIZION
®
Series Next-Genera-
tion Banknote Acceptor Unit. This section contains
the following information:
•
Tool Requirements
•
Pusher Unit Timing Belt Removal
•
Home Position Sensor Board/Home Position
Sensor FFC & Interface Connector Board
Removals
•
RFID Module & RFID Harness Removals
•
Validation CPU & Controller CPU Board Removals
•
USB FPC/Power FPC & Interface FPC Cable
Removals
•
Validation Unit Harness Removal
•
Interrupter Board Removal
•
Motor Unit Timing Belt Removal
•
Stacker Motor & Transport Motor Removals
•
Bezel Hold Chips A/B Removals
•
Sensor Transfer Board/CIS FFC/Transmissive
Light FFC & Upper UV FPC Sensor Removals
•
Validation Sensor Board Assembly Removal
•
Validation Sensor FPC Cable Removal
•
CIS/Transmissive Light/Upper UV Sensor
Removals
•
CIS/CIS FPC/Lower UV Sensor & Lower UV FFC
Removals
•
Validation Unit Timing Belt Removal
•
Reassembly Cautions.
Tool Requirements
The following tools will be required to perform
iVIZION disassembly and reassembly;
•
#1 & #2 Phillips Screw Drivers
•
#T6 “TORX” Brand Torque Wrench Driver
•
#1 & #2 Torque Wrench Drivers
•
Motor Gear Assembly Pressure Bar
•
Pliers
•
Tweezers
Pusher Unit Timing Belt Removal
iVIZION Standard and Large Cash Box
To remove the Timing Belt proceed as follows:
1. Remove the Cash Box from the
iVIZION
Unit.
2. Open the Cash Box Door.
3. Remove the two (2) screws (Figure 4-1
a
1
&
a
2
)
securing the Pusher Mechanism Unit to the Cash
Box.
4. While pulling upward on the Door Latch Stop-
a
1
&
a
2
) of the Pusher Mecha-
nism Unit (Figure 4-2
b
), slide it forward to
remove the Pusher Mechanism Assembly out of
the Cash Box.
5. Remove the four (4) screws (Figure 4-3
a
1
,
a
2
,
a
3
&
a
4
) securing the Unit Cover in place (Figure 4-
b
), and remove the Unit Cover from the Pusher
Mechanism Assembly.
4 DISASSEMBLY/REASSEMBLY
Figure 4-1
Figure 4-1
Pusher Mechanism Screws Removal
a
1
a
2
Figure 4-2
Figure 4-2
Pusher Mechanism Removal
a
1
a
2
b
