JCM GEN5 Series, Руководство по эксплуатации и обслуживанию

Страница: 45 / 70

P/N 960-100940R_Rev. A © 2016, JCM American Corporation
6 - 3
Firmware Updating and Testing GEN5™ Series Printer Section 6
4. Click the “
Next>
” Button (Figure 6-6 a ).
5. Click the “
Install
” Screen Button (Figure
6-7 a ) when the “
Ready to Install the Program
”
Screen (Figure 6-7) appears.
6. When the “
Installing FLIDFU Downloader
” Screen
appears, monitor the installation Progress Bar
(Figure 6-8
a ) until installation has completed.
The installation may take several minutes.
7. Once installation is complete, the “
InstallShield
Wizard Completed
” Screen (Figure 6-9) appears.
Click the “
Finish
” Screen Button (Figure
6-9 a ) to end the installation process.
8. When the “
FLIDFU Downloader Installer Informa-
tion
” screen appears, click the “
Yes
” Screen But-
ton to restart the PC.
This completes the “
FLDFU Downloader
” installation
procedure. Once installation is complete, the
FLDFU icon appears on the PC Desktop.
Firmware Download Procedure
To download GEN5 Printer Firmware to the GEN5
Printer Unit, proceed as follows:
1. Refer to Figure 6-1 to complete the necessary
Tool and Harness connections.
2. Connect the PC to the GEN5 Printer.
3. Double-click
the
“
FLDFU
”
icon on the PC Desk-
top to launch the
“
FLDFU Downloader
”
applica-
tion.
4. Look for verification of a valid connection to the
GEN5 Printer (Figure 6-11 a ).
Figure 6-6
InstallShield Wizard Welcome Screen
a
Figure 6-7
Ready to Install the Program Screen
a
Figure 6-8
Installing FLIDFU Downloader
a
Figure 6-9
Installation Completion Screen
a
Figure 6-10
Restart PC after FLDFU Installation