3200369_RCONTACT-R_EN_Rev02
Page 2/3
Mode Configuration of transmitter programming in the receiver.
Led R1
Led R2
1
When you open the pedestrian door, relay 1 on the receiver will be activated
ON
OFF
2
When you open the pedestrian door, relay 2 on the receiver will be activated
OFF
ON
3
When you open the pedestrian door, the two relays will be activated at the same time ON
ON
PRESS RPORG BUTTON LED TURNS ON
PRESS TRANSMITTER PROG ONE BEEP & PROGRAMMED
PRESS RPROG BUTTON
LED TURNS OFF & END PROG
Autotest signal
Check the autotest output on the control panel, in stanby, to see whether the voltage is 0V (positive polarization) or 12/24V ac/dc
(inverted test input). Switch on the autotest signal of the panel and check that it has a maximum duration of 3 seconds.
Autotest output
in standby
Autotest output
activated
Polarization type
Jumper
ATEST POL
ATEST1
ATEST2
Connection to a equipment with
autotest
0V
12/24V
Positive
OFF
Connected*
Connected*
12/24V
0V
Inverted
ON
Connected*
Connected*
Connection to a equipment without
autotest **
---
---
---
OFF
Not connected
Not connected
* Nota: Connect autotest only for used outputs.
** Where the autotest is not used, the system is not checked at the start of the operation, which means that security standard EN 12453 regarding the use of motorised
garage doors is, in some cases, not complied with..
Maintenance
Beeps and leds messages / errors indication table
B1/B2
Led
Check
Led
Beeps
Equipment
Message / error
Solution
ON
OFF
No beeps
RCONTACT R
Detection of pedestrian door at open state
---
RCONTACT transmitter not programmed
Verify if it must be programmed and perform the
programming.
Communication failure between RCONTACT R
and RCONTACT T
Verify the batteries of the emitter and if they are
charged, verify the radio signal with the Check
function.
OFF
OFF
4 beeps each
20 seconds
RCONTACT R
RCONTACT/T low battery
Verify the batteries of the transmitter
OFF
ON
No beeps
RCONTACT R
Check function. See coverage and signal quality
table.
---
System Check
This function has to be used to check the operation and range of all the devices once the installation has been carried out.
Press the receiver’s
CHECK
button for at least 1 second to enter check mode. The indicator light will come on and four beeps will be
heard.
Perform a complete door opening and closing manoeuvre. During the system check a beep will be heard every 1,5 seconds.
