1248090_Rev1.0
230START/230SOCKET
Page
2/2
Groups
Receivers can be configured with a group (from 0 to 7) so that there is no interference when working near each other.
Group configuration
The configuration can be carried out with the programming tool or by self-programming as follows.
Self-programming
After the receiver has been totally reset, it will be configured with the group of the first radio-programmed transmitter by enabling the
hands free mode.
Exception: If the receiver has been configured using programming tools, the group may only be changed with the programming tool.
Operations
On powering the receiver, the led will flash the same number of times as the group number with which it is configured.
Maintenance
Use of the receiver
These receivers are designed for use as remote controls for directly activating 230V equipment (up to 10A).
The manufacturer reserves the right to modify equipment specifications without prior notice.
Important annex
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the following requirements:
· For units which are permanently connected, an easily accessible circuit-breaker device must be built into the wiring system.
· This unit must always be installed in a vertical position and firmly fixed to the structure of the building.
· This unit must only be handled by a specialised installer, by his maintenance staff or by a duly trained operator.
· The instruction manual for this unit must always remain in the possession of the user.
· Terminals of maximum section 3,8mm2 must be used for the power supply connections.
· Do not open the device.
JCM TECHNOLOGIES, S.A., declares that this
230START, 230SOCKET
is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC and complies with the fundamental requirements of the 2004/108/EC Directive on
electromagnetic compatibility and 2006/95/EC on low voltage, insofar as the product is used correctly.
EC Declaration of conformity
See web
www.jcm-tech.com
C=channel
G=group
N.B. Group 0 enables all groups.
