JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
2 - 4
Section 2
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Installation/Operation
Connector Pin Assignments (Continued 1)
Table 2-3 lists the UBA-14 Rear Panel Connector Pin Assignments.
Table 2-3
UBA-14 Rear Panel Connector Pin Assignments
UBA-14 Rear Panel Connector
Pin
No.
Signal Name
*
*. Signal name, I/O, and function with parenthesis are for photo-coupler isolation and RS-232C only.
I/O
†
†. I/O (input/output) is the terminal viewed from Bill Acceptor’s side.
Function
1 +12V POWER
+12V DC power
2 GROUND (Power)
0V DC Ground Plain
3 M. RES
In
Bill Acceptor’s master reset signal line
4 PC/RS232C OUT
(Out)
Serial data signal output line from Acceptor to Controller
5 +12V I/F
+12V DC Interface Power
6 PC/RS232C IN
(In)
Serial data signal input line from Controller to Acceptor
7 GND I/F
Photo-coupler Zero (0) Volt DC Interface power
8 Vbus
USB Communication Vbus signal line: DC +5V
9 -DATA
IN/OUT USB Communication input/output signal line
10 +DATA
IN/OUT USB Communication input/output signal line
11 (TTL1)
(Out)
Reserved (TTL1) output
12 GND USB
USB Communication Ground: DC 0V
13 (GND I/F)
(Interface power: RS232C DC0V)
14 LED POWER
LED drive line - anode
15 (TTL1)
(In)
Reserved (TTL1) input
16 (TTL2)
(In)
Reserved (TTL2) input
17 (TTL3)
(In)
Reserved (TTL3) output
18 LED- (TTL2)
(Out)
LED Drive Line - cathode (TTL2)
19 (TTL3)
(Out)
Reserved (TTL3) output
20 NC
No Connection
Socket Jack: DRA-20PC-FO (JAE)
Contact Type: D02-22-26P-10000 (JAE)
Socket Plug: DRA-20SC-FO (JAE)
Contact Type: D02-22-26S-10000 (JAE)