jcb JCB-MS-210C, Инструкции и руководство пользователя

Страница: 24 / 29

24
JCB-MS-210C
Instruction & User Manual
Adjusting the laser (Fig. 6)
If the laser (31) ceases to indicate the correct
cutting line, you can readjust the laser. To do
so, open the laser switch (32) and set the laser
by moving sideways to that the laser beam
strikes the teeth of the saw blade (5).
Maintenance
If personnel qualified for unusual maintenance
tasks or repairs must be obtained during
of after the warranty period, please always
contact a service point recommended by us or
contact the manufacturer.
•
Only perform repair, maintenance and
cleaning work as well as the correction of
malfunctions with the drive switched off as a
basic rule.
•
All protective and safety equipment must
be reassembled immediately after repair,
maintenance is completed.
NORMAL SERVICE TASKS
Normal service tasks can also be performed by
untrained personnel and are all described in the
preceding sections and in this chapter.
•
The mitre saw must not be lubricated,
because it always cuts dry surfaces; all
moving machine parts are self-lubricating.
•
In the event of service work, personal
protective equipment must always be work
(protective goggles and gloves).
•
Remove saw dust and chips regularly by
cleaning the cutting zone and support
surfaces.
We recommend using a suction tool or brush.
ATTENTION: Do not use compressed air!
Check the saw blade from time to time: If
problems arise with the blade, it must be
ground by a specialist or replaced, depending
on the condition.
Fig. 6
32
31