jcb 2069289, Руководство оператора

Страница: 147 / 208

Maintenance
Engine
135 9821/6100-4 135
Notice: Do not exceed the correct level of engine oil in the sump. If there is too much engine oil, the excess
must be drained to the correct level. An excess of engine oil could cause the engine speed to increase
rapidly without control.
1. Make the product safe.
Refer to: Maintenance Positions (Page 122).
2. Wait for the oil to drain back into the engine sump before you take a reading. If not, a false low reading
may be recorded which can cause the engine to be overfilled.
3. Get access to the engine compartment (if applicable).
Refer to: Access Apertures (Page 125).
4. Remove and clean the dipstick.
Refer to: Service Points (Page 123).
5. Replace the dipstick.
6. Remove the dipstick.
7. Check the oil level. The oil should be between the two marks on the dipstick.
8. If necessary, add more oil:
8.1. Remove the filler cap.
Refer to: Service Points (Page 123).
8.2. Add the recommended oil slowly through the filler point
Refer to: Fluids, Lubricants and Capacities (Page 173).
8.3. Replace the dipstick.
8.4. Remove the dipstick.
8.5. Check the oil level, if necessary add more oil.
8.6. Replace the dipstick
8.7. Replace the filler cap.
9. Close and secure the engine cover (if applicable).
Replace
Notice: Do not exceed the correct level of engine oil in the sump. If there is too much engine oil, the excess
must be drained to the correct level. An excess of engine oil could cause the engine speed to increase
rapidly without control.
WARNING Hot oil and engine components can burn you. Make sure the engine is cool before doing this job.
Used engine crankcase lubricants contain harmful contaminants. In laboratory tests it was shown that used
engine oils can cause skin cancer.
CAUTION It is illegal to pollute drains, sewers or the ground. Clean up all spilt fluids and/or lubricants.
Used fluids and/or lubricants, filters and contaminated materials must be disposed of in accordance with
local regulations. Use authorised waste disposal sites.
1. Make the machine safe.
2. Get access to the engine compartment.
3. Remove the oil filler cap.
4. Remove the engine oil drain plug. Drain the oil in to a suitable container.
5. Clean the drain plug. Install the drain plug. Tighten the drain plug to the correct torque value.