JC MACHINERY & TOOLS INC.
Quality We Trust
5
side .And to the non-transparence material ,it also can be tested by resistance
pull after the whole party is cooled down.
4.
Mending the edge of the welding material smooth .The surface face to the front
side, and overlap to left down and right up .The width of pulled up is 120mm.
5.
Plug the welding material between the two iron wheels to make the parallel
between the body of the machine and the edge of mother material, and it can
weld itself after confirmed the temperature and the speed. Usually the operator
just watch the warp between the welding mark and the edge of the mother
material and timely rectify it within a small scope .At the end of material welding,
pick up the handle to separate the up and down iron wheels.
6.
Owing to the thermal inertial, it can adjust the temperature within small scope
to offset the discrepancy in temperature if it comes too high or too low in the
process of welding.
7.
In the process of welding, it can adjust through the two interior hexangular
screws on the swaying head if the welding mark is not equality in two outside.
(Just the corresponding screw in the upside of intensive welding deep or in the
upside of loosen welding mark shadow)
8.
Welded material crossed with another material in the shape of “T”. The ways of
welding is as the diagram below. Cut the crossing head sticking to the thermal
wedge off 12cm inclined.
Walking direction
