
· 11 ·
ALT. LOAD VOLTS
xx.xx V NORMAL
TEST OVER. TURN
OFF LOADS &
ENGINE
PRINT RESULT?
YES/NO
ALT. LOAD VOLTS
xx.xx V NORMAL
RIPPLE VOLTAGE
xx.xx V NORMAL
ALT. LOAD VOLTS
xx.xx V LOW
CHARGING SYSTEM NORMAL WHEN TEST WITH
ACCESSORY LOADS
CHARGING SYSTEM LOW
WHEN TEST WITH ACCES-
SORY LOADS
The alternator is not providing
sufficient current for the sys
-
tem’s electrical loads and the
charging current for the battery.
The system is showing normal
output from the alternator. No
problem detected.
Check the belts to ensure the alternator is rotating with
the engine running. If the belts are slipping or broken,
replace the belts and retest. Check the connections
from the alternator to the battery. If the connection is
loose or heavily corroded, clean or replace the cable
and retest. If the belts and connections are in good
working condition, replace the alternator.
10. Press «ENTER» when char-
ging system test is comple-
ted. Turn all accessory loads
and engine off. Press «EN
-
TER» to read the system
test results.
11. Press “ENTER” to press re-
sult or not.
IN-VEHIVLE TEST
This is a combination test of both battery test & system
test. Please refer to above testing procedures or follow
the instructions on the display of the tester.
The sole and exclusive remedy for any unit found to
be defective is repair or replacement, at the option of
the seller. In no event shall the seller be liable for any
direct, indirect, special, incidental, or consequential da-
mages (including lost profit) whether based on warran
-
ty, contract, tort, or any other legal theory.
CRANKING VOL-
TAGE
xx.xx V NORMAL
ALT. IDLE VOLTS
xx.xx V NORMAL