22
DUAL VRX932LAP
Unlike most conventional speakers, the VRX932LAP is
designed so that a pair of speakers may be safely mounted
onto a pole or tripod stand. For most applications, the
forward socket of the dual angle pole socket will be used.
This will tilt the lower of the two speakers at a 15°
down-angle (providing coverage of the near listeners) while
the upper speaker will face straight out (covering the more
distant areas). Ideally, the listeners should not be able to
see either the bottom or the top surfaces of the two-speaker
array. Usually, the Array Configuration Selector (ACS)
switches on the lower speaker's input panel should be set
to the “Short Throw (-3 dB)” position while the upper
speaker will be set to either “Short Throw (-3 dB)” or “Mid
Throw (0 dB)”.
Place the speakers on the pole or tripod one at a time. Be
sure to lock the two speakers together using the integral
rigging hardware (see below). System illustration shows
available JBL SS4-BK speaker pole and SRX718S
subwoofers.
Do not stack more than two VRX932LAP
speakers on a pole.
LOCKING (2) VRX932LAP LOUDSPEAKERS TOGETHER
Any time two or more VRX932LAP are arrayed together, they must be mechanically secured to each other using
the integral rigging frame and supplied quick release pins. See the diagram below for details.
WARNING:
Only the correct quick release pins supplied by JBL are to be used.
VRX_Powered_UsersGuid012808 copy 3.qxp 1/30/08 4:52 PM Page 22
