4
Important Safety Note:
The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speaker,
and for proper assembly
and installation of the wall-
mount bracket, including but
not limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and
installation instructions
carefully. If you have any
questions or doubts about
your ability to correctly wall-
mount the speakers, consult
your authorized JBL dealer
or custom installer.
Step 1: Unscrew and remove
the large
Molded Nut
™
. If
necessary, use the supplied
Metal Bar
∞
as a lever by
inserting it into one of the
holes in the outer edge of
the
Molded Nut
™
.
Step 2: Firmly grasp the
Ball
and Shaft
£
and pull it
straight out of the
Attach-
ment Plate
¢
. Avoid leaning
it to the side for leverage, as
this may break off a tab.
Step 3: Slide the
Molded Nut
™
onto the
Ball and Shaft
£
with the threaded open-
ing facing the ball. Thread
the
Metal Nut
¡
all the way
onto the
Ball and Shaft
£
,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
parts.
Step 4: Screw the
Ball and
Shaft
£
into the
Threaded
Insert
§
on the back of the
Satellite Speaker
¶
until it
is fully seated in the
Threaded
Insert
§
, but
do not tighten,
as you might dislodge the
Threaded Insert
§
. Such
damage would not be cov-
ered under the warranty.
Step 5: Tighten the
Metal Nut
¡
with the star washer side
between the
Metal Nut
¡
and the back of the
Satellite
Speaker
¶
, using large
needle-nose pliers until it is
firmly seated against the back
of the
Satellite Speaker
¶
and has locked the
Ball and
Shaft
£
and the
Satellite
Speaker
¶
together.
NOTE:
Once the
Metal Nut
¡
is fully tightened, it may embed
some marks on the back of the
Satellite Speaker
¶
. However,
these marks will be covered
by the
Metal Nut
¡
.
Step 6: Mount the
Attach-
ment Plate
¢
into a wood
stud on the wall, using four
#10 panhead wood screws
•
at least one inch long
(not supplied). Make sure
that all four screws are
driven into the stud and not
into drywall.
If the bracket
needs to be mounted in
drywall, the customer is
responsible for selecting
and using appropriate wall
anchors and screws.
IMPORTANT NOTE:
The
Metal
Nut
¡
must be fully tight-
ened against the
Satellite
Speaker
¶
as described in
Step 5 before beginning Step
7, in order to avoid damage
to the
Threaded Insert
§
.
WALL-MOUNTING
1
2
3
4
8
5
1
2
3
4
5
6
7
8
SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 6
