UK
4. Collection cap against CO
2
loss
5. CO
2
hose
JBL ProFlora T3
6. Holding clips with suction pads (1 x)
Installation
• First thoroughly rinse the diffuser in lukewarm water. Do not
use detergents.
• Fit the diffuser vertically in the aquarium in a location with a
slight current of water. The upper edge of the device should
be at least 2 cm under the surface of the water.
• Connect the CO
2
hose to the CO
2
source: for bio-CO2 systems
(e.g.
JBL Proflora bio80 und bio160
) to the hose connection
on the diffuser unit, for systems with a pressurised gas cylinder,
to the hose connection of the pressure regulator.
• At first the bubbles will flow intermittently through the spiral
bubble channel from the bottom to the top.
The device
needs approx. 48 hours to run in.
After this time a bio-film
will have formed, allowing the bubbles to rise freely upwards.
As they rise, the bubbles will become smaller as a sign of
the diffusion of the CO
2
into the surrounding water. Once the
bubbles are at the top, they reach the collection cap where
any remaining CO
2
can diffuse completely.
Note:
After some time the collection cap will fill with gas which now
and again escapes upwards through the ventilation openings.
This gas is not CO
2
, but “false” gas which is sometimes present
in small quantities in CO
2
cylinders or which diffuses into the
bubbles on their way upwards from the surrounding water.
Содержание ProFlora Taifun S
