JBL EVOi.sys, Руководство пользователя

Страница: 19 / 36

2TK LEVEL
The
2TK LEVEL
control sets the level of the 2-Track Tape
input, which is routed to the headphones, monitor outputs,
meters, or mix when
2TK TO MIX
is active (see next callout).
Connect the unbalanced RCA L/R inputs,
2T RETURN
, to the
tape machine’s unbalanced RCA outputs.
MONITOR Source Select
These switches allow a choice source for the phones, monitor
outputs, and meters. Normally the monitor source is either
MIX or SUB (or both, depending on which of the two right-
hand switches is selected), but pressing the 2TK switch swaps
the monitoring to the 2-track output. When the switch is
released, the normal
MIX or SUB selection is restored.
PFL/AFL LED
The
PFL/AFL
LED illuminates to show that a PFL or AFL is
active and is the source for the monitors and meters. The
LED will normally be off.
Bargraph Meters
Three-color peak-reading bargraph meters are provided to
monitor
2TK , MIX , or SUB signals, giving you a constant
warning of excessive peaks in the signal which might cause
overloading. Aim to keep the signal within the amber seg-
ments at peak levels for best performance.
Similarly, if the output level is too low and hardly registering on
meters, the level of background noise may become significant.
Take care to set up the input levels for best performance.
When any SOLO or AFL switch is pressed, the L and R meters
automatically switch to show the selected PFL or AFL signal on
both meters, in mono.
PHONES
This control sets the level of the monitor signal being sent to
the
MONITOR PHONES
output.
MONITOR
This control sets the output level being sent to the MONITOR
OUTPUTS L and R (on the rear panel) without affecting the
level to the meters.
MONITOR PHONES
The
MONITOR PHONES
output appears on a 3-pole 1/4"
phone jack for use with stereo headphones having an
impedance of 200 ohms or higher.
21
20
19
18
17
16
15
17
M I X E R O P E R A T I O N