JBL CINEMA VISION CVR700, Руководство по обслуживанию

Страница: 180 / 213

TC2001 Audio Signal Processor Pin Descriptions
( IC52,62,72,82)
Pin Function Description
1 BIASCAP Bandgap reference times two (typically 2.5VDC). Used to set the
common mode voltage for the input op amps. This pin is not capable of
driving external circuitry.
2, 6 FBKGND2,
FBKGND1
Ground Kelvin feedback (Channels 1 & 2)
3 DCMP Internal mode selection. This pin must be grounded for proper device
operation.
4, 7 FBKOUT2,
FBKOUT1
Switching feedback (Channels 1 & 2)
5 VPWR Test pin. Must be left floating.
8 HMUTE Logic output. A logic high indicates both amplifiers are muted, due to the
mute pin state, or a “fault”.
9, 12 Y1, Y2 Non-inverted switching modulator outputs.
10, 11 Y1B, Y2B Inverted switching modulator outputs.
13 NC No connect
14 OCD2 Over Current Detect input.
15 REF Internal bandgap reference voltage; approximately 1.2 VDC.
16 OCD1 Over Current Detect input.
17 VNNSENSE Negative supply voltage sense input. This pin is used for both over and
under voltage sensing for the VNN supply.
18 OVRLDB A logic low output indicates the input signal has overloaded the amplifier.
19 VPPSENSE Positive supply voltage sense input. This pin is used for both over and
under voltage sensing for the VPP supply.
20 AGND Ground.
21 V5 5 Volt power supply input.
22, 27 OAOUT1, OAOUT2 Input stage output pins.
23, 28 IN1, IN2 Single-ended inputs. Inputs are a “virtual” ground of an inverting opamp
with approximately 2.4VDC bias.
24 MUTE When set to logic high, both amplifiers are muted and in idle mode.
When low (grounded), both amplifiers are fully operational. If left floating,
the device stays in the mute mode. Ground if not used.
25, 26 BBM1, BBM0 Break-before-make timing control to prevent shoot-through in the output
MOSFETs.
Cinemavision CVR700
180