www.jbl.com
E
ngli
sh
3
SouNdBAr PLACEMENt
PLACING THE SOUNDBAR ON A TABLE
If your TV is placed on a table, you can place the soundbar on the table
directly in front of the TV stand, centered with the TV screen. As long
as the surface of the table is flat, the soundbar will rest on its rubber
bumpers.
• Set the soundbar’s EQ switch in the “Table” position. See
Soundbar
Rear-Panel Controls and Connections,
on page 2.
WALL-MOUNTING THE SOUNDBAR
If your TV is attached to a wall, you can use the included wall-mount
bracket to mount the soundbar on the wall directly below the TV
screen.
1. Determine the location for the soundbar on the wall. Make sure that
the top of the soundbar will not block your view of the TV screen
when it is mounted on the wall.
2. Hold the bracket against the wall as a template and mark the
locations of the soundbar wall-mount bracket holes on the wall. The
two holes should be spaced 4-9/16" (115mm) apart, and the bracket
slots are designed to accept 4mm screws. Make sure that the holes
are at the same height. See the illustration below.
Mark Bracket Hole Locations
4-9/16" (115mm) Apart
3. Attach the wall-mount bracket to the wall at the locations you
marked, using hardware that is appropriate for the wall’s construction
and materials. Note that the soundbar weighs 2.5kg (5.5 lb). Be sure
to use hardware that can support this weight.
Before you tighten the mounting screws all the way, use a carpenter’s
level, laser sight or other device to check if the bracket is level. The
bracket’s slots allow you to adjust the bracket’s angle on the wall to
ensure that it is level. Once the bracket is level, tighten the mounting
screws.
4. After reading the
Connections
section on page 4, bring all the cables
through the opening in the bracket, as shown in the illustration
below, and connect them to the soundbar.
IMPORTANT: Do NOT plug the soundbar’s power cord into an AC
outlet at this time.
Bring all
Cables Through
Bracket Opening
• Set the soundbar’s EQ switch in the “Wall” position, and set the
soundbar’s Power switch in the “On” position. See
Soundbar Rear-
Panel Controls and Connections,
on page 2.
5. Attach the soundbar to the bracket by sliding the bracket’s upper
tabs into the slots at the top of the soundbar’s connector section.
The bracket’s lower tabs should snap into the slots on the botton of
the soundbar (If necessary, rotate the front of the soundbar down
slightly to get the tabs into the slots.)
Insert Tabs on Bracket
into Slots on Soundbar
