jbc PSS, Инструкция по эксплуатации

Страница: 5 / 16

40 mm
50 mm
60 mm
80 mm
100 mm
130 mm 130 mm
para manuales - color gris
200 mm
300 mm
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
2
3
40 mm
50 mm
60 mm
80 mm
100 mm
130 mm 130 mm
para manuales - color gris
200 mm
300 mm
5
Height Adjustment
The support incorporates a height adjustment mechanism inside the support legs. Choose between
3 different height levels.
Lift the support while holding the tabs and let its feets drop down under their own weight (2).
While continuing to hold the lower tabs, place the support on the workplace and lower it until it
reaches the desired height.
Release the tabs and the legs will automatically lock into position (3).
Note:
Make sure that the components already mounted on the PCB do not come too close to the
preheater plate.
If components are too close to the heating surface, they may be damaged. To avoid this, set the
support height to level 2 or level 3 or set an adequate PCB holder angle to ensure sufficient distance.
Pay special attention when turning the PCB holder upside down.
To adjust the height, press the two lower push tabs upward at the same time and hold them
pressed (1).
Level 1
Without support elevation
Level 3
Support elevation
22.5 mm / 0.89 in
Level 2
Support elevation
10 mm / 0.04 in
Push tabs located on both sides of the support