Choose the needle and the suction cup that best fits the component and start working as follows:
Maximum working temp: 250ºC (482ºF)
Operation
1. Suction
Pick & Place
Ref. T260-A
2. Release
This tool helps you easily place and remove SMDs of any size thanks to the suction pump.
Pick & Place
(not supplied with JT)
Press the button to
start/stop the suction
Once the suction is
activated, cover the
pen hole with your
finger and lift off the
component.
Insert the needle
with the appropriate
cup for a correct
suction process.
Lift your finger
to release the
component in the
appropriate place.
You should
avoid the needle
protruding from the
lower part.
Pick & Place
Ref. T260-A
Straight Needles Set
Ref. 0901546
Bent Needles Set
Ref. 0861660
10
11
Only perform this operation when the element is cold and the unit is disconnected from the mains.
1.
Loosen the screw.
2.
Pull the heating element away from the handle.
3.
Connect the new heating element, ensuring its pushed all the way in.
4.
Tighten the screw.
Replacing the Heating Element
Heating Hose Set
Ref. JT-T1A (100V / 120V)
JT-T2A (230V)
Heating Element
Ref. 0014107 (230V)
0014105 (100V / 120V)
Handle
Ref. 0009829
1.
Ensure that the tool is turned off.
2.
Use a spanner to unscrew the connecting nut.
3.
The tube end of the new heater must be inserted
so that the longitudinal rib fits into the groove.
5.
Follow the same steps conversely.
Changing the JT-TA Heater Hose Set
10
www.jbctools.com
11
