jbc CDE-BA Series, Инструкция по эксплуатации

Страница: 14 / 20

Clean
periodically
Before carrying out maintenance, always allow the equipment to cool.
- Clean the station screen with a glass cleaner or a damp cloth.
- Use a damp cloth to clean the casing and the
tool. Alcohol can only be used to clean the
metal parts.
- Periodically check that the metal parts of the
tool and stand are clean so that the station
can detect the tool status.
- Maintain tip surface clean and tinned prior to
storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat transfer
to the solder joint.
- Periodically check all cables and tubes.
Maintenance
Replace the blown fuse as follows.
1. Pull off the fuse holder and remove the fuse. If necessary use a tool to lever it off.
2.
Insert the new fuse into the fuse holder and return it to the station.
- Replace any defective or damaged pieces. Only use original JBC spare parts.
- Repairs should only be performed by a JBC authorized technical service.
*The Earthing Fuse minimize the risk of damaging the equipment when the tip touches a part with
an active voltage. If the Earthing Fuse is blown, the station will show a message indicating that the
fuse needs to be replaced.
Be aware that if the station keeps working in this conditions, the tip to ground resistance would not
meet the specifications.
Earthing Fuse * Imput Fuse
14