jbc BT-A, Руководство пользователя

Страница: 4 / 7

ø 1
ø 1,5
ø 3,5
A A
B
Mark
6 7
Operation
AC Console
The LEDs indicate the station’s different working
modes.
1. Station without a tool connected: The
green IN USE light flashes with the sequence
(- - -- --)
.
2. Tool out of the support: The green IN USE
light is permanently lit, indicating that the soldering
iron tip is at working temperature.
3. Tool in the support (sleep mode): The yellow
SLEEP light is permanently lit.
In order that the tool goes into sleep mode, the tool
must be in its support and the programmed sleep
temperature must be less than the temperature
on the dial or the prefixed temperature.
4. Station with previously fixed temperature.
(Only for users of the AC console).
Soldering iron out of support:
- If the dial is above the prefixed temperature,
the green IN USE light is lit the majority of the
time, switching off briefly at regular intervals
(___ ___) .
- If the dial is below the prefixed temperature,
the green IN USE light is off the majority of
the time, lighting up briefly at regular intervals
(- - -) .
- If the dial is at the prefixed temperature, the
green light is permanently lit.
Errors
When the handpiece or the cartridge is in an
open circuit, the green IN USE light flashes with
the sequence
(- - - - - -) .
When the handpiece or the cartridge is in a short
circuit, the green IN USE light flashes with the
sequence
(- - - - - - - - -)
.
If any of the above mentioned causes is corrected,
the station will start working automatically.
If the station is used continually in a overloaded
condition for a period of time, the system will
stop and both leds will flash simultaniusly. Switch
station off and on to reset and review the soldering
application.
Yellow LED
(SLEEP)
Green LED
(IN USE)
Dial
The original parameters of control unit can be
modified using the
AC console.
It is necessary to connect the console AC with
software revision 7.0 or later to the BT in order
to configure it (consult JBC for console software
updates).
Previous versions only allow for reading of
counters and do not allow for modification of
parameters
Configuration possible:
- Fixing the working temperature.
- Selection of temperature units ºC or ºF.
- Modification of sleep temperatures and standby
times.
- Adjustment of temperature.
- Reset the parameters back to factory settings.
- Read-out data:
- Working hours.
- Sleep cycles and sleep hours.
- Cartridge and iron changes.
- Program version.
Quick Tip Changer
Round Chisel Round
bent
Bevel
Special models
Compatible cartridges
The BT stations work with C245 cartridges and T245/T470 handpieces or C210 cartridges with T210
handpieces. Find the model that best suits your soldering needs in
www.jbctools.com
Save time and change cartridges safely without switching the station off.
1. Removing 2. Inserting 3. Fixing
Place the handpiece in the
extractor and pull to
remove the cartridge. Place the handpiece on top
of the new cartridge and
press down slightly. Use the holes for fixing the
cartridge* as follows:
A.
For straight C210.
B.
For curved C210.
C.
For C245.
*
Important
It is essential to insert the cartridges as far as the mark for a proper connection.
www.jbctools.com
B
C
A