WSF 80
Thermo-regulated soldering iron gun with manual solder wire feed.
Technical data:
Voltage supply: 230 V 50 and 60 Hz
Max power: 80W
Power regulation: PWM from 0 to 100%
Max temperature: 550°C @ 100%
Cable: 3 x 0.75 H03 Schuko male connector
Weight: 320 gr.
Consist of:
•
WSF
80
•
6 gr. Lead-free wire SACX0307 1mm coil
•
WB 10 1mm and WB 15 1.5mm wire-guide
pipe
•
2mm
EX
key
•
Empty spare coil
•
SF25 2,5 sqmm
INSTRUCTIONS
Choose a tube guide wire 1 or 1.5 mm suitable for w
SnPb alloys give 1mm min, max
1.5 mm).
Insert the end of the wire, perfectly straight, into t
e gun holding down the lever until the soldering
p, (check the correct insertion through the windo
e orientation of the wire to the tip, act on the
urve Tips
Tubetti guidafilo
Max Temperature
ire diameter (use lead-free or
he rear hole of th
w).
ti
Adjust the pre-load on the external spring acting on the knob, it is recommended to exercise the minimum
pressure to avoid the deformation of the wire.
If the wire blocks, holding down the lever and pull it out, after cutting the deformed part, proceed to a new post.
Connect the tool to the mains (230V ~) the indicator begins to flash.
TIN THE TIP AS SOON AS THE MELTING TEMPERATURE IS REACHED
Pushing the trigger, the wire advances toward the tip, for a length adjustable from 1 to 6 mm. To adjust the amount
f wire needed, act on the grain, in front of the trigger; for adjusting th
o
grain beneath the thread guide
.
Model
Longlife c
WSF 80
80W-230V~ SF25
384899
SF10
(Ø1.0)
T0051384999
SF15
(1.6)
T0051385099
SF25
(2.5)
T0051385199
85299
TB/70/10
Ø 1.0
T0051385399
TB/70/15
Ø 1.5
T0051385499
100% = 550°C
T0051
SF40
(4.0)
T00513
READ THE FO
LLOWING IMP
N REGARDING THE SAFETY USE OF THE DEVICE
Before connecting the appli
nameplate data corresponds with the mains.
This appliance must only be used for the purpose it was designed.
Do not touch the appliance with wet hands and / or feet are wet.
Do not pull the cord or the appliance itself to remove the plug from the socket.
Before performing any maintenance, disconnect the appliance from the mains and allow to cool.
Do not use non-standard extensions (IMQ-VDE-NF-ETC..)
This tool can be placed on a holder when not in use
WARRANTY
Weller warrants this product against defects in workmanship for one year from date of purchase documented, in
case of absence of such documentation will be considered the date of manufacture.
The warranty excludes all parts subject to wear.
The warranty is void in case of tampering or improper use of the device.
Transport costs are paid by the customer.
ORTANT INFORMATIO
ance make sure that the
