JB Systems Space-4 Laser, Руководство по эксплуатации

Страница: 7 / 60

ENGLISH USER MANUAL
JB SYSTEMS
®
5/54 SPACE-4 LASER
HOW TO SET UP AND CONTROL THE UNIT
MUSIC INPUT SENSITIVITY:
The unit works to rhythm of the beat when used in standalone or master/slave mode
To set the input sensitivity, follow these steps:

Press the FUNC-
button until the display shows “S 0” …”S 9”

Press the ENTER-button to confirm your choice.

Use DOWN and UP button to select a value between “S 0” (very low sensitivity) and “S 9” (high
sensitivity).

Once the mode is selected, press the ENTER button save it.
You can operate the unit in 5 ways:
1) MUSIC CONTROLLED MODE:
The laser runs a preprogrammed sequence to the rhythm of the music. Select this mode when only 1 laser
is used (standalone) or when the laser is placed as the first (master) unit in a chain with several units.

Press the FUNC-button until the display shows one of the following: Sou or Aut.
Please check carefully the Menu chart above.

Now use the UP or DOWN buttons to select
“Sou”

Press the ENTER-button to confirm your choice.
You can connect several LASERs together: just put the first unit of the chain in one of the sound activated
effect modes and all other units in “Slave mode” (display shows “SLA”) to make them all work in perfect
sync!
Note: When no music is detected, the laser output will be shut off (blackout).
2) FULL AUTOMATIC MODE:
The laser automatically runs a preprogrammed sequence. Select this mode when only 1 laser is used
(standalone) or when the laser is placed as the first (master) unit in a chain with several LASERs.

Press the FUNC-button until the display shows one of the following: Sou or Aut.
Please check carefully the Menu chart above.

Now use the UP or DOWN buttons to select
“Aut”

Press the ENTER-button to confirm your choice.
The laser automatically runs a preprogrammed sequence.
You can connect several SPACE-4 LASERs together: just put the first unit of the chain in one of the
automatic effect modes and all other units in “Slave mode” (display shows “SLA”) to make them all work in
perfect sync!
3) SLAVE MODE:
The laser follows the instructions given by the first SPACE-4 LASER (master) in the chain.

Connect the DMX input of the laser to the DMX output of the previous laser in the chain.

Press the FUNC-button until the displ
ay shows “SLA”

Press the ENTER-button to confirm your choice.
You can connect several lasers together. Please put the first unit of the chain in “Music or automatic
mode” and all other units in “Slave mode” (display shows “SLA” to make them all work in perfect sync!