ENGLISH
OPERATION MANUAL
JB SYSTEMS®
6/89
SM-1612 SCANMASTER
7. AUDIO input:
receives audio from any line or record output on audio equipment. If
this input is not used, the internal microphone of SM-1612 takes over.
SET UP
1. FIXTURE SETUP:
SM-1612
has 12 “fixtures buttons”. Each fixture button
represents 16 DMX-addresses. (8faders on page A and 8faders on page B) In
most cases SM-1612 will be used with fixture having 8 or less DMX addresses.
This means that in most cases only page A will be used.
The following chart helps you setting up the DMX-start address on your fixtures:
Fixture #
Digital Setting
Dip Switch Setting
1
1
1 “On”
2
17
1 and 5 “On”
3
33
1 and 6 “On”
4
49
1,5 and 6 “On”
5
65
1 and 7 “On”
6
81
1,5 and 7 “On”
7
97
1,
6 and 7 “On”
8
113
1,5,6 and 7 “On”
9
129
1 and 8 “On”
10
145
1,5 and 8 “On”
11
161
1,6 and 8 “On”
12
177
1,5,6 and 8 “On”
2. JOYSTICK SETUP:
For each fixture any 2 addresses can be assigned to the PAN
and TILT of the joystick:
Press and hold the “Program” button until its LED blinks.
Press 2 times
the “Mode” and “Fine” buttons at the same time. The assign LED
should light. (if reverse LED is lit, press both buttons a second time together)
Use the bank UP and DOWN keys to select the axis you wish to assign (PAN or
TILT).
If your fixture has more than 8 DMX addresses, you can u
se the “Tap/Display”
button to select 16 or 8 channel mode.
Press the button corresponding to the fixture you wish to edit.
While holding the mode button press the scene number corresponding to the
slider which controls the movement. (Example: If pan is controlled by slider
number 4, press and hold the “Mode” button while pressing scene button 4).
When both PAN and TILT are assigned,
press the “Mode” and “Fine” buttons at
the same time again to exit Assign mode.
Note:
you can still use the channel faders instead of the joystick to control the
movements of the fixture.
1. DELETE JOYSTICK SETUP FOR A FIXTURE:
Enable Programming Mode.
(Press and hold the “Program” button until its LED blinks)
Press 2 times
the “Mode” and “Fine” buttons at the same time. The assign LED
should light. (if reverse LED is lit, press both buttons a second time together)
If your fixture has more than 8 DMX addresses, you can u
se the “Tap/Display”
button to select 16 or 8 channel mode.
Press the button corresponding to the fixture you wish to edit.
