ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
2/14
BUBBLE-01
Don’t cover any ventilation openings as this may result in overheating.
Prevent use in dusty environments and clean the unit regularly.
Keep the unit away from children.
Inexperienced persons should not operate this device.
Maximum save ambient temperature is 40
°C. Don’t use this unit at higher ambient temperatures.
Make sure to always place the unit on a stable surface, never install the unit above the audience, a little
liquid can always drip from the fog output.
Always unplug the unit when it is not used for a longer time or before you start servicing.
Check that the available voltage is not higher than the one stated on the rear panel of the unit.
The power cord should always be in perfect condition. Switch the unit immediately off when the power cord
is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Never let the power-cord come into contact with other cables!
This unit must be earthed in order comply with safety regulations.
In order to prevent electric shock, do not open the cover.
Never
repair a fuse or bypass the fuse holder.
Always
replace a damaged fuse with a fuse of the same
type and electrical specifications!
In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
The housing must be replaced if they are visibly damaged.
Please use the original packing when the device is to be transported.
Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
OPERATING INSTRUCTIONS
Do not overfill your bubble machine. Overfilling will cause the unit to leak.
Do not tilt or angle the bubble machine. This may result in bubble liquid spilling out of the liquid tray.
Don’t use an ordinary soap solution, always use good quality bubble liquid to fill up the tank.
Make sure to plug the bubble machine in a mains wall socket with earth connection
Turn on the power switch located on the back of the bubble machine. The internal bubble drum will begin
to rotate and the internal fan will be activated. Bubbles will now be constantly generated until the power is
switched off.
MAINTENANCE
Switch off the unit, unplug the mains cable.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
SPECIFICATIONS
Mains Input:
AC 240V, 50Hz
Fuse (size: 5x20mm):
5A / 250V
Power:
30 Watt
Bubble output :
2400 bubble/min
Tank size:
0,75L
Size:
200 x 240 x 210 mm
Weight:
1,6 kg
All the information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.jb-systems.eu