JB-Lighting SPARX 10, Руководство по эксплуатации

Страница: 68 / 72

- 68 -
10
Zoom & focus:
The zoom effect in all Sparx10 is calibrated at the factory. But if necessary it is possible to fine-
tune the zoom using the ZOOM OFS command.
To ensure a long and satisfying performance of the fixture, check function of the fans in the
head and in the base from time to time. Most important: make sure that there is no dust or fluff
covering the louvres. To clean the fixture open the head cover and the baseplate. Use a brush
and a vacuum cleaner to remove dust and fluff. Don´t damage or bend any parts. Incompetent
performance of the maintenance will invalidate the warranty claims. Consult qualified service
technician!
RECEIVESOFT
Use the RECEIVE SOFT command to prepare the Sparx10 for a software upload. See 6.3 soft-
ware update and the uploader device documentation.
6.2 Cleaning the fixture
WARNING: Disconnect fixture from mains, and allow unit to cool down for at
least 10 minutes! With direct view on the beam source use a welding
goggle of reduction 4-5!
ATTENTION: Débranchez l‘appareil du secteur et le laissé refroidir au moins 10
minutes! Lors d‘un regard direct dans la source lumineuse il est
fortement recommandé de porter une lunettes de soudeur équipée
de verres à vision atténué degré 4-5!!
!
!
6.3 Software update
6.4 Verifying electronic devices
To update the fixture via PC/Notebook, a upgrade dongle (USB/DMX converter) with software is
required. The upgrade dongle has to be connected to the fixture with a 5 pin XLR connector. The
software for the products is available from the JB-Lighting homepage at
www.jb-lighting.de .
In accordance with the applicable German safety regulations (Accident Prevention and Insur-
ance, DGUV regulation 3 / regulation 4), electrical installation and equipment have to undergo
inspection at regular intervals. For this purpose, the fixing screw of the 5-pin DMX socket may
serve as measuring point for the insulation and fault current measurement. This screw is con-
nected to all sheet metal parts by means of a contact disc.
PE - measurement point