Jays q-Seven Wireless, Быстрый старт

Страница: 3 / 4

Quickstart guide
1. Power on
To power on, press and hold the multi-function button for 2 seconds until the operation LED lights up in white.
2. Pairing
The headphones enters pairing mode automatically when powered on, indicated by the operation LED flashes quickly in red and white.
To pair, go to Bluetooth
® settings on your device and select “JAYS q-Seven Wireless”. The operation LED will flash slowly in white upon a successful connection.
3. Wear and use
Place the ear cup marked with “L” on the inside on your left ear. Place the earcup marked with “R” on the inside on you right ear.
4. Use the NC button
To enter ANC mode, single click the NC button, the NC LED will light up in white.
To enter HearThrough mode, single click the NC button, the NC LED stays white.
To go back into ANC mode, single click the NC button, the NC LED stays white.
To turn off ANC or HearThrough, hold the NC button for 2 seconds, the NC LED turns off.
5. Charging
The operation LED flashes quickly three times in red as the battery level is running low.
Charge by connecting the included USB cable to the USB jack on the bottom of the right ear cuff and connect it to any certified USB power output.
The operation LED will glow in red during the charging.
When the headphones are fully charged, the operation LED will glow in white for 10 seconds, then the operation LED turns off. A full 100% charge will take around
2-3 hours (depending on temperature and charger).
6. Power off
Press and hold the multi-function button for 5 seconds. The operation LED flashes once in red and then in both red and white before the headphones powers off.
If the Bluetooth
® on the paired device turns off, the headphones will turn off automatically after a few minutes.
EN English