![background image](http://html1.mh-extra.com/html/jayco/seneca-prestige-2023/seneca-prestige-2023_owners-manual_3690460112.webp)
106
Section 11: Electronics
Exterior Entertainment Center
The exterior entertainment center is located on the curbside of the unit. You can access the
entertainment center by opening the exterior cargo door to the stationary open position.
Refer to the individual component manufacturer’s information for detailed operating in-
structions.
HDTV Antenna/Satellite System
Your recreation vehicle may be equipped with an exterior amplified high definition TV an
-
tenna. The antenna comes equipped with a signal meter and a power injector to aid in
receiving the strongest possible signal when tuning in HDTV stations.
Antenna Positioning:
The knob on the base inside the RV is used to rotate the outdoor roof
antenna. The arrow on the knob should be pointed towards the TV signal source (TV sta-
tion). Press the button on the side of the knob and turn it to rotate the antenna for optimum
signal. The antenna will rotate a full 360°.
NOTE: This antenna is a fixed height (12”) and cannot be lowered or raised.
Trees and foliage will interfere with receiving a strong HDTV signal.
Power Injector (if so equipped)
The power injector button located on the wall plate, switches between your cable/satellite
signal and the over-the-air (OTA) HDTV signals. When the button on the wall plate is
turned ON, it lights green and interrupts the satellite/cable input to the TV. It allows the OTA
HDTV signals from the outside roof antenna to your TV. When the button is turned OFF,
satellite/cable signals are resumed on your TV.
Signal Strength Meter (if so equipped)
The base may have a built in signal strength meter to aid in obtaining maximum TV sig-
nal. A row of LED lights will light up on the face of the base enclosure to indicate signal
strength. Optimum signal is indicated when the maximum number of LEDs are lit.
•
Make sure the power injector is turned ON at the wall plate which turns power on to
the antenna.
•
To turn on the signal meter, slide the black button on the side of the base (arrow in
photo).
•
Rotate the small attenuator knob on the face of the base enclosure clockwise.
•
Press the button on the side of the large knob with the arrow, and rotate it until the
maximum number of LEDs light.
•
Rotate the small attenuator knob counter-clockwise until the last illuminated LED light
flickers.
•
Rotate the large antenna knob to illuminate the last flickering LED light.
•
Refer to your TV (or converter box) manual for information on scanning for available
OTA channels.
Antenna Power Supply (if so equipped)
For good station reception, the antenna power supply must be turned ON to
view local television stations. Turning the antenna power supply ON sends
12-volt DC through the cable to the TV roof antenna. The voltage energizes
the transistors in the antenna head amplifier. The TV signal then comes down
the cable to the outlets.Turn the antenna power supply OFF to view cable
television or to use a VCR or DVD. The ON/OFF switch is located on the
wall plate for the antenna connection.
Antenna
Power Supply
Table of Contents
Содержание SENECA PRESTIGE 2023
