![background image](http://html1.mh-extra.com/html/jayco/seneca-2023/seneca-2023_owners-manual_3689428106.webp)
100
Section 8: Plumbing System
Toilet
Prior to using the sanitation system, it is strongly recommended to flush the toilet several
times to release sufficient water into the holding tank. Generally, more water is required only
when flushing solids.
Winterize the BLACK TANK FLUSH
1.
Black tank should be empty prior to winterizing.
2.
Rinse the black tank prior to blowing it out with air.
3.
Attach the 4” sewer hose to the dump connector under the RV.
4.
Open the waste gate valve for the black tank (under the RV).
NOTE: If the RV has a macerator system, you need to open
the bypass valve for the macerator under the RV. This will al-
low the black tank to drain through the 4” sewer hose.
5.
Attach a garden hose to the TANK FLUSH inlet at the utility cen-
ter.
6.
Attach the other end of the hose to a pressurized water source.
Turn water on.
7.
Flush tank until water appears clear in 4” sewer hose.
8.
Turn off water, disconnect the hose from faucet, disconnect hose from tank flush.
9.
Connect the blowout plug to the Black Tank Flush inlet at the utility center panel.
10.
Colored valves have no effect on the black tank flush inlet.
11. Connect the air hose to the blowout plug. Set the compressor to
30 PSI maximum
.
12. Open the black tank drain gate valve, macerator bypass valve is open also.
13.
Blow air into the flush inlet for 30 to 60 seconds.
14. Disconnect the air hose, compressor and blowout plug.
15. Close the black tank drain gate valve and close the macerator bypass valve.
Draining the Spray Port
With fixtures and drain valves open in the RV to drain the water lines, connect the blue-
coiled hose to the brass quick connect fitting at the Spray Port.
1.
Remove the spray nozzle from the other end of the hose.
2.
Hold the open end of the hose near the ground and any water in the line should drain
out.
3.
Disconnect the hose from the fitting, and store in the RV.
4.
Close the port cover.
Winterizing the Spray Port with Antifreeze (if so equipped)
1.
As you are putting antifreeze into the water lines, attach the hose to the Spray Port.
2.
Have a container close by to capture antifreeze.
3.
Pull the trigger on the spray nozzle until antifreeze comes out (into the container).
4.
Release the nozzle and disconnect the hose from the port.
5.
Rinse out the hose before storing it.
Table of Contents
Содержание SENECA 2023
