![background image](http://html1.mh-extra.com/html/jayco/north-point-2023/north-point-2023_owners-manual_3662292047.webp)
41
Section 4: Vehicle Operation
F
- Retract All button puts leveling system in full retract mode
NOTE: Pressing both the arrow buttons simultaneously turns on the touch-
pad. Touchpad will time out after 7 minutes of non-use.
Auto Level Touchpad LED Indicator status
OFF -
Touch pad is locked
Solid Green -
Touch pad is active
Blinking Green -
Jacks are moving
Solid Red -
Low battery
Blinking Red - Error
The OneControl touch screen or Leveling App will show the specific error.
Refer to troubleshooting section of the manufacturer’s manual to clear the error.
Auto Leveling Touch Pad
Unhitching the RV
1.
Before unhitching from the tow vehicle, ensure the RV is parked on a level surface and
tires are chocked.
2.
Extend the inner legs of both landing gear (front jacks) to within 4”- 5” of the ground
by pulling on the quick release pins.
3.
Turn on the touchpad by pressing both arrow buttons simultaneously. LED illuminates
solid green.
4.
Press the UP arrow button to extend the front jacks to lift the front of the RV taking
weight off the hitch.
5.
Uncouple the RV connection to the tow vehicle. Pull tow vehicle away.
Auto Leveling
When the leveling cycle has started, it is important there is no movement inside the
RV until leveling is complete. Failure to remain still during leveling could affect the
performance of the leveling system.
1.
Turn on the touchpad.
2.
LED will light up solid green.
3.
Select AUTO LEVEL and the auto leveling process begins. Front of the RV will seek
a position near level. Rear jacks will be grounded (on 4-point system). Side to side
leveling will begin.
4.
Each jack will perform a final grounding touch.
On a 6-point system, the (2) middle jacks will be grounded to stabilize the trailer. The (2)
middle jacks do not level the RV.
If the AUTO LEVEL sequence does not perform as described above, place the system
in manual mode and test that the jacks operate correctly by using the OneControl
touch panel inside the RV.
OneControl Touch Panel
1.
Press the button at the bottom of the touch panel to power up the display.
2.
Select MyRV® Control Panel from the menu listing.
3.
Select the Leveler icon.
The following functions can be operated using the OneControl Touch Panel inside the RV.
Standard Mode and Menu
Basic Jack operation
Unhitching instructions
Auto Leveling
Table of Contents
Содержание NORTH POINT 2023
