Jayco JAY FLIGHT BUNGALOW 2023, Руководство пользователя

Страница: 66 / 151

60
Section 5: Slideout Systems
MAJOR and MINOR faults
; faults must be cleared for the room to operate normally.
 MINOR
faults can be cleared by pushing and releasing the
IN
or
OUT
buttons
on the wall touchpad.
 MAJOR
faults must be cleared by pushing and releasing the SET STOPS/CLEAR
FAULTS button located on the back of the wall touchpad.
™
NOTE: For MAJOR faults, the control must be overridden by following the
EMERGENCY RETRACT MODE in the OVERRIDE MODES section.
F a u l t
Code
F a u l t
Type
Fault Codes
Description Possible Cause Possible Solution
1 Major
Stops not
programmed
-Stops have not been
set
-Stops were cleared
-Stops were improperly
set
Steps need to be pro-
grammed by an authorized
service facility.
2 Minor System Fault
-Obstruction present
-Excessive system drag
Run room in opposite direc-
tion. If it continues to move
in the opposite direction,
remove obstruction, exces-
sive weight in room or repair
of damaged component. If
room stops moving in oppo-
site direction, observe fault
code and refer to this chart
4 Major
Excessive
Battery
Voltage
-Bad or loose connec-
tion
-Defective harness
-Open or shorted motor
-Check all connections at
control box and motor.
-Check the harness for bro-
ken wires.
-Put 12.0 VDC direct to the
motor. If it does not run,
replace the motor.
Park brake LED flashing
-Parking brake not set
(if applicable)
-Ground signal lost at
park brake control
-Set parking brake (if ap-
plicable)
-Check for continuity to
ground on wire plugged
into park brake connector at
control box.
6 Minor
Supply voltage to
control box is 17 0 V DC
or greater
Check 2-pin power connector
at control box. If the voltage
is 17. VDC or higher, contact
O.E.M for power and ground
supplies
Table of Contents