111
Section 8: Plumbing System
Toilet
Prior to using the sanitation system, it is strongly recommended to flush the toilet several
times to release sufficient water into the holding tank. Generally, more water is required only
when flushing solids.
The toilet system will perform better when water is run for ten to fifteen seconds after flush
-
ing to ensure that the waste will proceed to the bottom of the tank.
If there is not a sufficient amount of water used during flushing, the waste materials may
not evacuate properly from the drain line to the tank. Clogged tanks and pipes could eventu-
ally occur. For added convenience and better sanitation system performance, it is advisable
to always have four to six inches (10 - 15 cm) of water in the toilet. It is important to add
enough water to prevent solid waste buildup. The following guidelines will help to prevent
solid waste buildup.
Sewage (black) tank preparation
1.
Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2.
Follow the directions on your (approved RV) toilet chemical bottle (customer sup-
plied), by placing the recommended quantity of holding tank chemical into the toilet
bowl.
3.
Flush the toilet and allow at least two gallons (8 liters) of water to flow into the holding
tank.
Cleaning and Maintenance
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
For detailed information refer to the manufacturer’s operator manual.
It is important to prevent solid waste buildup. Follow the toilet manu-
facturer’s recommended instructions each time after emptying the black
water holding tank.
To help prevent toilet blockage, always use RV grade single-ply toilet pa-
per. Do not flush paper towels, diapers, sanitary napkins or other foreign
objects down the toilet.
Do not use chlorine (undiluted) or caustic chemicals, such as laundry
bleach or drain opening types, in the toilet system. These products dam-
age the seals in toilets and dump valves.
1.
Remove the spray nozzle from the other end of the hose.
2.
Hold the open end of the hose near the ground and any water in the
line should drain out.
3.
Disconnect the hose from the fitting, and store in the RV.
4.
Close the port cover.
Winterizing the Spray Port with Antifreeze (if so equipped)
1.
As you are putting antifreeze into the water lines, attach the hose
to the Spray Port.
2.
Have a container close by to capture antifreeze.
3.
Pull the trigger on the spray nozzle until antifreeze comes out (into the container).
4.
Release the nozzle and disconnect the hose from the port.
5.
Rinse out the hose before storing it.
Table of Contents
Содержание JAY FLIGHT BUNGALOW 2023
