Jayco JAY FEATHER Towables 2020, Руководство пользователя

Страница: 52 / 177

Section 4: Vehicle Operation
50
Campsite Hook-Up

Refer to
Electrical Systems
section before connecting the shore line power cord
(when using full hook-up) OR before starting the generator (if so equipped) or
operating the vehicle on 12-volt power when dry camping.

Refer to
Fuel & LP System
section before using the LP system. Open the LP gas
tank valve (if so equipped) slowly. There may be air in the lines and five to thirty
seconds of time is needed to bleed air before LP vapor fills the lines.

Refer to
Plumbing Systems
section before connecting the fresh water supply or
turning ON the water pump or water heater.

When using full hook-up, connect the sewer hose to the campsite sewer hook-up.

If applicable, start the refrigerator and the cooling or heating system.
NOTE: For extended dry camping, management of all your re -
sources is essential. Check your battery levels and conserve battery
power, use it sparingly
Stabilizer Jacks
The stabilizer jacks must be fully retracted before moving or towing the RV to prevent
stabilizer jack damage.
DO NOT USE THE STABILIZER JACKS TO LEVEL THE RV.
It is important to remember that the stabilizer jacks are to be used only for
support while occupying and moving around the RV. They are not designed to
support the weight of the RV.

Rear Backup Camera Prep
Your recreation vehicle has been pre-wired to allow for installation of a (customer supplied
& customer installed) rear backup camera and a customer installed (or dealer installed) cam-
era ON/OFF switch so the backup camera can be used as an observation/security camera.
Depending on your RV model, a camera accessory power wire is pre-routed at the factory
from the rear camera, to the bedroom or the command center panel inside the entrance door.
An ON/OFF switch would be installed (by the customer or the dealer) either in the bedroom
or in or near the command center panel. The camera accessory power wire would be at-
tached to this switch. The camera monitor is then plugged into the camera charge center
in the bedroom or near the command center panel to be used for observation or security
purposes.
Certain models may have a pre-installed power switch for the camera located in an exterior
compartment. (e.g. battery storage or utility center bay) Your dealer can tell you if your
model comes with a switch pre-installed.
An instruction sheet is included with your RV detailing the installation of the backup cam-
era, and the camera power switch. It also explains where to find the camera accessory power
wire in your particular model RV. This instruction sheet is included in your Warranty Packet.