![background image](http://html1.mh-extra.com/html/jayco/hummingbird-2018/hummingbird-2018_owners-manual_3585622112.webp)
Section 8: Plumbing System
108
9.
Open all hot water faucets one by one until water begins to flow continuously and a
chlorine smell is noticeable. Include outside shower faucets (if so equipped).
10. Close the hot water faucets and repeat opening all cold water faucets one by one until
you smell chlorine. Include outside shower faucets (if swo equipped) and toilet.
11. Turn OFF the water pump.
12. Let the solution remain in the tank & lines for at least four hours when disinfecting with
50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM chlorine
concentration should be permitted to sit in the system for at least one hour.
13. After the required period, drain the chlorine solution from the fresh water system.
Since the water heater was bypassed there should be no sanitizer in the (storage) tank
water heater.
Rinse the system with fresh water:
14. Fill the fresh water tank full of clean (potable) water. Fill fresh water tank from an
external container. Pour fresh water into the gravity fill inlet using a hose (or funnel).
15. Power to water heater should be OFF. (both switches: electric & LP gas) When the
fresh water tank is full: Turn the pump ON to send water through the lines.
16. Run water through all faucets (hot & cold, including outside shower) until chlorine
smell is gone. Turn faucets and outside shower off, turn pump OFF.
17. Then, drain the fresh water system again (see Draining the Fresh Water System).
18. Set water heater bypass to NORMAL: Allows water into the water heater. Replace
the water heater drain plug.
19.
Refill the fresh water tank with fresh water again and when water heater is full of water,
turn the water heater power ON. Refer back to Step 14 above for instructions on
refilling the fresh water tank.
Follow the steps outlined in Draining the Fresh Water System with one exception, do not
drain the water heater. Water heater bypass valves set to BYPASS (Refer to Water Heater
Bypass section) Do not remove the water heater drain plug.
Remove the cartridge water filter (if equipped) and replace it with the bypass tube included
with your RV.
NOTE:
To thoroughly sanitize the fresh water tank, the unit
should be driven around for a period of time allowing the
solution to splash the sides and top of the tank
NOTE:
:
If a chlorine taste lingers in the water, flush the water
system with a solution consisting of one-quart vinegar to five
gallons of clean water. Re-flush as necessary.
The vinegar
solution may damage the water heater or the water filter,
so both must be bypassed again before performing this
operation.
Table of Contents
Maintenance Record
Содержание Hummingbird 2018
